Work continues on the barn, the first two posts can be found here and here.

They used the super big fork-lift thing (I’m sure it has a real name but super big fork-lift thing will have to do) to get the cement discs into each of the holes and then began setting up the posts. 

It was at this stage that I realized the overhead door on the east side of the barn is not where I had wanted it to be in my original plan. After a really good conversation with the crew I realized I couldn’t have it where I wanted and I will just have to sort it out once we get to stage two and putting the stalls in. The frustrating thing is I could have had it where I wanted it and saved money had someone sat down with me sooner and laid out exactly how the building would actually be built and then we would have opted for a smaller door that could have gone exactly where I wanted it to, and been cheaper. But at this stage the plans have been designed and everything purchased and it would cost money to make such a major change. I’m slightly frustrated because I thought I had worked out all these types of details earlier in the process but lesson learned. Not that I will get to apply that lesson since I will not be building another barn, but perhaps some day you, dear reader, can apply that lesson. They may tell you they can build around any size (and they mostly can) but plan everything out in multiplies of eight and plan on eight-foot centers and everything will go smoother.

After the east side was up they moved on to the west side.

The overhead door on the west side also had to get adjusted a bit but that one doesn’t have any ramifications to the stall area.

After both sides were done they put up the north end-wall. They are leaving the south end-wall for very last so they can continue to bring the super big fork-lift, as well as the various other big equipment, in and out while the put everything up.